is an independent, privately owned company dedicated to bringing you high quality, innovative products made right here in our Wood Village, Oregon manufacturing facility. began business in May, 2006 after acquiring machinery from a company that ceased domestic swivel manufacturing to source their products overseas.

Yes! All of our products are made right here in our Wood Village, Oregon facility.Īre you folks a division of Uncle Mike’s?.How do I install M-LOK? (Video Instructions) Here is a helpful link for installing push button swivel bases: Push Button Swivel Base Installation The use of a light coat of two-part epoxy on the threads is optional, but recommended. How do I install GrovTec barrel bands? (Video Instructions)ĭo I need to use glue or anything when I install a push button base? (Installation Video) How do I install GrovTec sling? (Video Instructions) How do I install GrovTec locking swivels? (Video Instructions) Then further tightening will torque it down.SELECT A CATAGORY & CLICK TO OPEN ANSWERS VIDEO INSTRUCTIONS The 'lobes' on the T-nut are there to ensure that if the nut is pre-set to the proper distance from the accessory, then inserted into the MLOK slot, the nut should rotate easily 90 degrees (so the nut is perpendicular in the slot) before meeting resistance. The part did feel solid in hand at the time. I was afraid it would have enough bite for a secure hold. Mine were at about 45 degree or less of an angle if I did it that way. Its keeping the nut perpendicular to the slots. I had no problems getting the nut to catch on the inside. As some of the earlier posters mentioned, it's easier if you pre-tighten the nut most of the way, then push the nuts through, hold the mlok section against the rail and tighten the allen head. Magpul uses a special nut that locks on the slot and lets you tighten it right down. I have both but M-Lok is only one to make me curse and want to remove handguard to add a rail.Then your doing it wrong.

Which way to install keymod accessories